Suzuki 2006 SX4, Service Manual

Page: 1023 / 1478

Air Bag System: 8B-58
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance”, if any.
• Repeat “Air Bag Diagnostic System Check” to confirm that the trouble has been corrected.
4 Floor harness circuit check
1) Disconnect applicable “L384” or “L385” connector under
front cushion.
2) Check for proper connection to floor harness connector
at terminal “L385-1” and “L385-2” (for DTC B1061) or
terminal “L384-1” and “L384-2” (for DTC B1065).
3) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
4) Measure resistance between “L04-12” and “L385-1”
terminals, between “L04-11” and “L385-2” terminals (for
DTC B1061).
5) Measure resistance between “L04-13” and “L384-1”
terminals, between “L04-14” and “L384-2” terminals (for
DTC B1065).
Is each measured resistance 1
Ω
or less?
DTC B1061: Repair
high resistance or open
wire in “BLU” or “BLK”
circuit at driver side-air
bag harness.
DTC B1065: Repair
high resistance or open
wire in “BLU” or “BLK”
circuit at passenger
side-air bag harness. DTC B1061: Repair
high resistance or open
wire in “GRY/RED” or
“GRY” circuit at floor
harness.
DTC B1065: Repair
high resistance or open
wire in “BRN/WHT” or
“BRN” circuit at floor
harness.
Step Action Yes No
“L384”, “L385”
(A)
“L04-12” “L04-13” “L04-14” “L04-11”
1,(A)
“L384-1”, “L385-1” “L384-2”, “L385-2”
I7RW01822079-01