Power Assisted Steering System: 6C-13
Motor Drive Voltage (V)
This parameter indicates the voltage between motor
terminals.
System Power Status (EPS System Power, ON, OFF)
This parameter indicates input status of EPS system
power supply.
IGN switch Status (ON, OFF)
This parameter indicates the condition of the power
supply through the ignition switch.
Torque sensor Status (ON, OFF)
This parameter indicates the output status of the torque
sensor power supply.
Fail Safe FET Status (ON, OFF)
This parameter indicates the status of the motor drive
power supply circuit.
P/S System Symptom Diagnosis
S6RW0C6304008
This section describes trouble diagnosis of the P/S system parts whose trouble is not indicated by the on-board
diagnostic system (self-diagnostic function). When no malfunction is indicated by the on-board diagnostic system
(self-diagnosis function) and assuredly those steering basic parts as described in “Steering Symptom Diagnosis in
Section 6A” are all in good condition, check the following power steering system parts which may be a possible cause
for each symptom of the steering.
Condition
Possible cause
Correction / Reference Item
Steering wheel feels
heavy (Perform “Steering
Force Check:” before
diagnosis.)
Steering wheel installed improperly
(twisted)
Install steering wheel correctly.
Poor performance of P/S motor
Check P/S motor referring to “P/S Motor and
Its Circuit Inspection”.
Poor performance of torque sensor
Check torque sensor referring to “Torque
Sensor and Its Circuit Inspection”.
Steering gear case assembly
malfunction
Replace steering gear case assembly.
Poor performance of vehicle speed
signal from BCM
Check vehicle speed signal circuit referring to
“DTC C1121 / C1123 / C1124: Vehicle Speed
Signal Circuit Failure”.
Steering wheel feels
heavy momentarily when
turning it to the left or
right
Steering gear case assembly
malfunction
Replace steering gear case assembly.
Poor recovery from turns
Poor performance of torque sensor
Check torque sensor referring to “Torque
Sensor and Its Circuit Inspection”.
Steering gear case assembly
malfunction
Replace steering gear case assembly.
Vehicle pulls to one side
during straight driving
Poor performance of torque sensor
Check torque sensor referring to “Torque
Sensor and Its Circuit Inspection”.
Steering gear case assembly
malfunction
Replace steering gear case assembly.
Abnormal noise
P/S motor (built in steering gear case
assembly) malfunction
Replace steering gear case assembly.
No idle up
P/S control module faulty
Check P/S control module referring to
“Inspection of P/S Control Module and Its
Circuits”.
Summary of Contents for 2006 SX4
