2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of CF Moto U-Force 1000
Full Aero-Vent Polycarbonate Windshield
CF-1000-WD05 / 50-40065
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the windshield.
1.
Check over the parts included in the cartons with the parts list shown below:
1" Stainless Bolts
4 each
2" Stainless Bolts
2each
Small Washers
4 each
Metal Brackets
4 each
Plastic Thumb Nuts
4 each
Lock Nuts
2 each
1 ¼” Black Spacer
2 each
Plastic Slide Fasteners
14 each
50" End Bulb Gasket
1 each
28" ½” Wide Adhesive Rubber Padding
2 each
54" ½” Wide Adhesive Rubber Padding
1 each
Vent Sliders
2 each
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2.
Start by pulling it out of the box; find a clean area to lay it down and install the hardware. Next take the
50” End Bulb rubber gasket and starting at one end firmly place along the bottom edge of the
windshield. You will need to peel back the protective film from the edge to install the gasket. If you
leave the bulk of the protective film on while installing you can avoid scratching the windshield. Ensure
that the gasket is seated
fully home
on the along the edge to insure a good fit of the windshield.
