14 - 53
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory
addresses
Axis 1
Axis 2
Axis 3
Checking method
Remedy
102
252
402
Set
correctly.
Connect
correctly.
Call the status display and check the
regenerative load ratio.
1. Reduce the frequency of positioning.
2. Use the regenerative brake option of larger capacity.
3. Reduce the load.
Review the power supply.
1) The regenerative brake option has
overheated abnormally.
2) Error occurs even after removal of the built-
in regenerative brake resistor or
regenerative brake option.
Change the servo amplifier.
Change the servo amplifier or regenerative brake option.
Increase acceleration/deceleration time constant.
112
262
412
1. Re-set servo gain to proper value.
2. If servo gain cannot be set to proper value:
1) Reduce " Pr.112 Load inertia ratio" (load inertia
moment ratio); or
2) Reexamine acceleration/deceleration time constant.
Change the servomotor.
Correct the wiring.
Error code 2032 occurs if power is switched
ON after U, V and W are disconnected.
Change the servo amplifier.
Correct the wiring.
Take noise suppression measures.
1. Change lead.
2. Connect correctly.
Change the servo amplifier.
1. For wire breakage of built-in regenerative brake
resistor, change servo amplifier.
2. For wire breakage of regenerative brake option, change
regenerative brake option.
Add regenerative brake option or increase capacity.
Review the power supply.
Connect
correctly.
Change the cable.
Take noise suppression measures.
Connect
correctly.
Set
correctly.
Review the operation program.
Take noise suppression measures.
Change the AD75.
Summary of Contents for A1SD75M1
