Mitsubishi A1SD75M1, User Manual

Page: 604 / 746

14 - 16
MELSEC-A
14 TROUBLESHOOTING
Division of
error
Error
code
Error name Description Action at occurrence of error
533
Condition data
error
One of the following is applicable when
condition data is referred to for a conditional
start, wait start or JUMP command.
•
The target condition setting is out of the
setting range.
•
The condition operator setting is out of the
setting range.
•
The condition operator is range designation
“1” and parameter 1 is smaller than
parameter 2.
534
Special start
command error
The command code of the special start
command is out of the setting range.
Operation is terminated.
536
M code ON
signal ON start
Positioning start is performed when the “M
code ON” signal (XD, XE, XF) is turned ON.
537
PLC READY
OFF start
Positioning start is performed when “PLC
READY” (Y1D) is turned OFF.
538 READY ON start
Positioning start is performed when AD75
READY (X0) is turned ON.
543
Outside start
number range
•
The “positioning start number” setting is other
than 1 to 600, 7000 to 7010, 8001 to 8050, or
9000 to 9003 at positioning start.
•
When the absolute position restoration mode
is the "infinite length mode", the "positioning
start No." setting in the axis control data is
9002 or 9003 at a positioning start.
Operation does not start at the start.
Positioning
operation
544
Outside radius
range
The arc radius exceeds 536870912.
At start: Operation does not start.
During operation: Immediate stop
900
Outside unit
setting range
•
The setting range of “unit setting” in basic
parameter 1 is out of the setting range.
•
When the zero point return detailed
parameter "absolute position restoration
selection" is "1: infinite length mode" and the
axis monitor data "absolute position
restoration mode" is "1: infinite length mode",
the basic parameter 1 "unit setting" setting is
other than "2: degree".
901
No. of pulses per
rotation setting
error
The setting range of “No. of pulses per rotation”
in basic parameter 1 is out of the setting range.
902
Movement
amount per
rotation setting
error
The setting range of “movement amount per
rotation” in basic parameter 1 is out of the
setting range.
Parameter
903
Unit
magnification
setting error
The setting range of “unit magnification” in
basic parameter 1 is out of the setting range.
At start: Operation does not start.
During operation: Immediate stop