Mitsubishi A1SD75M1, User Manual

Page: 288 / 746

6 - 12
MELSEC-A
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
6.4 Positioning program examples
An example of the "Axis 1" positioning program is given in this section.
[No. 1] to [No. 3] parameter and data setting program
* When setting the parameters or data with the sequence program, set them in the AD75 using the
TO command from the PLC CPU. (Carry out the settings while the PLC READY signal [Y1D] is
OFF.)
* When setting the parameters or data with the AD75 software package, the [No. 1] to [No. 3]
program is not necessary.
No.1 Parameter setting program
(For basic parameter 1 axis 1)
*
*
*
*
<Setting of unit setting (0:mm)>
<Setting of No. of pulses per rotation>
<Setting of movement amount per rotation>
<Setting of unit magnification (1-fold)>
<Setting of basic parameters 1 to AD75>
No.2 Positioning data setting program
(For positioning data No.1 axis 1)
*
*
*
*
*
*
*
*
<Positioning identifier>
Operation pattern : Positioning complete
Control method : 1-axis liner control (ABS)
Acceleration time No.:1, Deceleration time No.:2
<Setting of positioning identifier>
<Setting of M code (9843)>
<Setting of dwell time (300ms)>
< (Dummy data) >
<Setting of command speed (180.00mm/min)>
<Positioning address (412.6 m) setting>
<Setting arc address (0.0 m)>
<Setting of positioning data No.1 to AD75>