Mitsubishi A1SD75M1, User Manual

Page: 605 / 746

14 - 17
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
Setting range
(Setting given in sequence program)
Remedy
Correct the start block data.
Refer to section "5.4 Start block
data."
<Special command>
00
H
to 07
H
Correct the special start data.
(Refer to section 5.4 Da. 12 )
1153 1203 1253
<M code OFF request>
1: The M code ON signal is turned OFF.
Turn the “M code ON” signal OFF then start.
(Refer to section 12.7.3)
Check the sequence program in which the PLC READY
signal (Y1D) is turned ON or OFF. Turn PLC READY ON
then start.
Check AD75 READY OFF then start.
(Refer to section 3.4.2)
1150 1200 1250
<Positioning start No.>
1 to 600, 7000 to 7010,
8001 to 8050, 9001 to 9003
Correct the positioning start No.
Refer to section “5.3 List of
positioning data.”
<Max. radius>
536870912
Correct the positioning data.
(Refer to sections 9.2.6 and 9.2.7)
0 150 300 0, 1, 2, 3
1 151 301 1 to 65535
2 152 302 1 to 65535
3 153 303 1, 10, 100, 1000
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).