Alcatel Omni Switch/Router, User Manual

Page: 784 / 1100

Generic Service UDP Relay
Page 26-20
Forward to VLANs
Use this parameter to list, add, or delete
VLANs
to which the
NBNS UDP
relay will forward.
This default is
UNSET
. This value redisplays as
SET
when at least one
VLAN
is configured. Up
to 32
VLANs
may be configured. You can list forwarding
VLANs
, or add or delete
VLANs
from
the forwarding list by entering
434=l
,
434=a
, or
434=d
on the command line.
To configure a generic service:
1. On the Add new Generic Service menu, enter a description of the generic service. For
example:
431=TFTP
2. Enter the relevant
UDP
port number. For example:
432=69
3. At least one next-hop address must be configured. To add an address, enter:
433=a
The screen displays similar to the following:
FORWARD TO Server List
Item Server address Server Name (if known)
Enter IP address or host name of server to be added to list [‘h’ for help/<ret> to exit]:
4. Enter the next-hop address in dotted decimal format (i.e., 198.206.181.12), a hexadecimal
address (i.e., 0xc6ceb501). A host name (i.e., system.com) may be entered if the
DNS
resolver is enabled using the
res
command.
5. When you are finished entering next-hop addresses, press
<Enter>
to return to the prompt
for the Add new Generic Services menu.
6. Select any
VLANs
for the relay to forward to. At the prompt, enter
434=a
A screen similar to the following displays:
Available/Selected VLANS
Item Group ID:VLAN ID MASK IP ADDR
1) 1:1 255.255. 0. 0 172. 23. 9.105 *
* = selected for forwarding
Enter item number of VLAN to be selected [‘h’f or help/<ret> to exit] :
7. Enter the item number of the group/
VLAN
that you want to select. Repeat this step for all
the groups/
VLANs
you want to select. An asterisk displays next to all selected
VLANs
.
8. Press
<Enter>
to return to the Add new Generic Services menu. Add any other generic
services in this way.
9. Enter
d
to keep the current changes and return to the Generic Services menu. Enter
d
to
return to the UDP Relay Configuration screen.
10. Enter
s
to save the changes and reinitialize the relay.