Alcatel Omni Switch/Router, User Manual

Page: 1008 / 1100

Viewing T1 Remote Statistics
Page 33-20
Viewing T1 Remote Statistics
To receive and monitor remote statistics on T1 ports you must enable the Facility Datalink
(
FDL
) protocol through the
temod
command. These statistics will not be available if you do
not enable
FDL
.
Note
Because there is no
FDL
standard for E1 configura-
tions, remote statistics are not supported on E1 ports.
Viewing Total Remote Statistics
You can view remote statistics occurring during the past 24 hours on a single port by enter-
ing the following command
terts <slot>/<port>
where
<slot>
is the slot number where the board is located, and
<port>
is the port number on
the board on which you want to view statistics. For example, to view remote 24-hour statis-
tics for Port 2 on the board in slot 5, enter
terts 5/2
A screen similar to the following displays:
Remote 24-hour Period Statistics for port 2 on slot 5
Circuit Identifier
: Alcatel T1 Circuit
Valid Intervals : 1 of 96 Elapsed Time : 1 of 900
ES SES BES UAS DM SEFS LES CSS PCV LOFC
====== ====== ====== ====== ====== ====== ====== ====== ====== ======
0 0 0 0 0 0 0 0 0 0
Most of the definitions of the fields and columns in this display are the same as those used for
the
telts
command. See Viewing Total Local Statistics on page 33-17 for an explanation of
these statistics. The remaining statisitics are described below.
LOFC
. Loss of Frame Count. A loss of frame count is the accumulation of the number of times
a “Loss of Frame” is declared.