Alcatel Omni Switch/Router, User Manual

Page: 906 / 1100

Viewing Configuration Parameters for the WSX
Page 29-34
Viewing Port Parameters
To view port parameters, enter the following command
frview <slot>/<port>
where
<slot>
is the slot number where the
WSX
board is located, and
<port>
is the port
number on the
WSX
board on which you want to view information. For example, if you
wanted to view configuration parameters for Port number 1 on the
WSX
board in slot 2, you
would enter
frview 2/1
or
frv 2/1
A screen similar to following displays:
Frame Relay port for Slot 2, Port 1.
1) Description................................................................... = Port1
2) Administrative Status .................................................. = UP
3) DLCMI Type.................................................................. = ANSI T1.617 Annex D
31) DLCMI Type ........................................................... = User
4) Poll Verification Interval T392 (seconds ) ...................... = 15
5) Full Status Interval N391/nN1 ....................................... = 6
6) Error Threshold N392/nN2............................................ = 3
7) Monitored Events Counter N393 ................................... = 4
8) Default Bridging Group ................................................ = 1
9) Default Frame-Relay Bridging Mode ............................. = Bridge All
10) Default Routing Group ................................................ = 0
11) Default Compression Admin Status............................. = Enabled
12) Default Compression PRetry Time .............................. = 3
13) Default Compression PRetry Count ............................. = 10
This screen lists all the current values for the listed parameters. These parameters are the
same ones set through the
frmodify
command. For detailed information on these values, see
Modifying a Port on page 29-22.