Alcatel Omni Switch/Router, User Manual

Page: 905 / 1100

Viewing Configuration Parameters for the WSX
Page 29-33
Viewing Configuration Parameters for the WSX
You can view all current parameters for a
WSX
port or an individual virtual circuit using the
frview
command. These parameters will be either the default parameters or parameters you
modified using the
frmodify
command or network management software.
You have a choice of viewing parameters at the chassis, port or
DLCI
(virtual circuit) level.
You receive different configuration choices depending upon which level you choose. The
sections below describe both ways to use the
frview
command.
Viewing Parameters for all WSXs in the Chassis
To view port parameters for all WSX boards in a chassis, enter the following command
frview
or
frv
A screen similar to following displays:
Frame Relay Configuration for Chassis:
Intf Speed Default Default
Slot/Port Type BPS Clocking Bridging Grp Routing Grp
========= ====== ======= ======== ============ ===========
3/1 V35DTE 0 External 1 0
3/2 V35DCE 0 External 1 0
3/3 *NONE* 0 External 1 0
3/4 *NONE* 0 External 1 0
Only ports configured as frame relay (see the
wpm
command in Chapter 49) will be displayed
in this screen. This screen lists all the current values for the listed parameters. These parame-
ters are the same ones set through the
frmodify
command. For detailed information on these
values, see Modifying a Port on page 29-22. For detailed information on the
Intf Type
column,
see Intf Type on page 29-39.