Alcatel Omni Switch/Router, User Manual

Page: 970 / 1100

Modifying a WAN Link
Page 31-10
2. Make the desired changes to each of the fields on this screen, then enter the
save
command to implement your changes.
The system prompt will then reappear.
Modifying WSX Links
1. To modify a WAN Link, you must enter its Link Index with the command. For example, to
modify Link Index 2 which uses a WSX physical port (serial or Fractional T1/E1), you
would enter the following command:
linkmodify L2
A screen similar to the following displays:
Modify Serial Port Link configuration. Peer ID: 2 Link Index: 2
Type: WSM port Slot: 5 Port: 1
1) Link Description : Link Entry: 2, Peer ID: 2
{Enter text up to 30 characters}
2) Link Administrative Status . . . . . . . . . . . . . . . . . . . . . . . . . . = Enabled
{(E)nabled, (D)isabled}
(save/quit/cancel)
:
The fields on this screen are the same as those produced by the
linkadd
command. See
Adding a WAN Link on page 31-3 for descriptions of each of these fields.
2. Make the desired changes to the fields on this screen, then enter the
save
command to
implement the changes.
The system prompt will then reappear.