3-31
3.2 Messages and Actions
3
W-2419
Initializing of distribution
section(M661/D661) failed.
Open and close magazine door. If
problems persist, consult your
technical representative.
Distribution home position cannot be
detected.
(Causes of the error message)
1. Poorly connected or broken
harness between the distribution
home position sensor (for M661)
(D661) and JND8 on the JND23
circuit board
2. Poorly connected or broken
harness between the distribution
slide motor (M661) and PDA13 on
the PDA23 circuit board
3. Faulty D661
4. Faulty M661
5. Faulty distribution slide
mechanism
6. Faulty PDA23 circuit board
7. Faulty CTL23 circuit board
1. Connect the harness correctly, or
repair or replace it.
2. Connect the harness correctly, or
repair or replace it.
3. Replace D661.
4. Replace M661.
5. Replace the distribution unit.
6. Replace the PDA23 circuit board.
7. Replace the CTL23 circuit board.
W-2421
Paper end processing of upper
magazine completed.
Replace magazine.
If not replaced, press [Print Stop] to
cancel print instruction.
Paper end sensor detects paper end.
(Causes of the error message)
1. Paper end
2. Poorly connected or broken
harness between the upper
magazine paper end sensor
(D616) and JND2 on JND23 circuit
board
3. Faulty D616
4. Faulty CTL23 circuit board
1. Load paper. If paper remains,
perform 2 to 4.
2. Connect the harness correctly, or
repair or replace it.
3. Replace D616.
4. Replace the CTL23 circuit board.
W-2422
Paper end processing of lower
magazine completed.
Replace magazine.
If not replaced, press [Print Stop] to
cancel print instruction.
Paper end sensor detects paper end.
(Causes of the error message)
1. Paper end
2. Poorly connected or broken
harness between the lower
magazine paper end sensor
(D626) and JND3 on JND23 circuit
board
3. Faulty D626
4.. Faulty CTL23 circuit board
1. Load paper. If paper remains,
perform 2 to 4.
2. Connect the harness correctly, or
repair or replace it.
3. Replace D626.
4. Replace the CTL23 circuit board.
W-2423
Unknown magazine ID is set.
Set correct magazine ID.
Different magazine ID from the last
magazine’s is used when replacing
magazine at paper end.
(Causes of the error message)
1. Paper magazine has been
replaced.
2. ID chip has been replaced.
3. Poorly connected or broken
harness between the upper
magazine ID sensor (D610 to
D615) and JND2 on the JND23
circuit board
4. Poorly connected or broken
harness between the lower
magazine ID sensor (D620 to
D625) and JND3 on the JND23
circuit board
5. Faulty D610 to D615
6. Faulty D620 to D625
7. Faulty CTL23 circuit board
1. Change print size, or use the
previous magazine.
2. Change magazine registration
data.
3. Connect the harness correctly, or
repair or replace it.
4. Connect the harness correctly, or
repair or replace it.
5. Replace D610 to D615.
6. Replace D620 to D625.
7. Replace the CTL23 circuit board.
No.
Message
Factor
Actions