5-114
5.6 Printer Adjustment/Maintenance (05)
This procedure adjusts the soft nip timing, nip position
and motor current value of the sub-scanning unit.
[Selection]
[Setup and Maintenance]
→
[05 Printer Adjustment/
Maintenance]
→
[0557 Sub-scanning Soft Nip Fine
Adjustment]
1. Enter the feed length in the “Feed length” box.
2. Select “Upper” or “Lower” for “Magazine”.
3. Click the [Print] button.
• After about three minutes, adjustment Prints 1 to
9 are output.
4. Select optimum prints for unevenness level at the
leading and trailing ends from nine adjustment
prints
5. Enter the optimum print numbers in the “Tip No. 1
to 9” and “End No. 1 to 9” boxes.
6. Click the [Convert] button.
• Timing, new pulse adjustment and motor current
values are displayed.
7. Select “Selected ID only” or “All IDs”.
8. Enter the ID in the “Magazine ID” box if “Selected
ID only” is selected.
9. Click the [Set] button for “Adjustment value”.
10. Click the [Set] button for “Motor current value”.
11. Click the [Close] button.
• Operation returns to the menu screen.
5.6.24
Sub-scanning Soft Nip Fine Adjustment (0557)
