NXP Semiconductors Kinetis KE1xZ256, Reference Manual

Page: 230 / 1325

• Minor loop mapping is enabled (CR[EMLM] = 1) and
• SMLOE = 0 and DMLOE = 0
If minor loop mapping is enabled and SMLOE or DMLOE is set, then refer to the
TCD_NBYTES_MLOFFYES register description. If minor loop mapping is disabled,
then refer to the TCD_NBYTES_MLNO register description.
Address: 4000_8000h base + 1008h (32d × i), where i=0d to 7d
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
SMLOE
DMLOE
NBYTES
W
Reset x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x*
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
NBYTES
W
Reset x* x* x* x* x* x* x* x* x* x* x* x* x* x* x* x*
* Notes:
x = Undefined at reset. •
DMA_TCDn_NBYTES_MLOFFNO field descriptions
Field Description
31
SMLOE
Source Minor Loop Offset Enable
Selects whether the minor loop offset is applied to the source address upon minor loop completion.
0 The minor loop offset is not applied to the SADDR
1 The minor loop offset is applied to the SADDR
30
DMLOE
Destination Minor Loop Offset enable
Selects whether the minor loop offset is applied to the destination address upon minor loop completion.
0 The minor loop offset is not applied to the DADDR
1 The minor loop offset is applied to the DADDR
NBYTES Minor Byte Transfer Count
Number of bytes to be transferred in each service request of the channel.
As a channel activates, the appropriate TCD contents load into the eDMA engine, and the appropriate
reads and writes perform until the minor byte transfer count has transferred. This is an indivisible operation
and cannot be halted. It can, however, be stalled by using the bandwidth control field, or via preemption.
After the minor count is exhausted, the SADDR and DADDR values are written back into the TCD
memory, the major iteration count is decremented and restored to the TCD memory. If the major iteration
count is completed, additional processing is performed.
Memory map/register definition
Kinetis KE1xZ256 Sub-Family Reference Manual, Rev. 3, 07/2018
230 NXP Semiconductors