Nortel BCM 3.7, Manual

Page: 155 / 1004

Viewing station module information 155
Programming Operations Guide
PRI version information
DTM modules that are set to PRI and BRI modules display additional PRI information under
Ports on bus, Port <number>, Channels, B1/B2, Addons . By clicking on the Addon 01 heading,
you can view information about the version of the downloadable firmware component being used
in this module. By clicking on the Addon 02 heading, you can view information about the version
of the downloadable protocol component being used on this module.
You can enable or disable any port. Refer to “Disabling/enabling a port channel setting” on page
160 .
Viewing station module information
The following figure shows a typical example of the headings for a station media bay module.
Figure 39 Station media bay module Bus headings
When you click on a bus that has a station module installed, you will see a screen that indicates the
type of module, the number of ports that are busy on the module, and the operational state of the
module.
Figure 40 Bus assigned to a station module
Programming Note: If the Actual Bus Type reads None , choose the correct setting in the
Programmed Bus Type field. After the system initializes to the module, the Actual Bus Type
Bus 06
Ports on Bus
Port 0201
Channels
B1
Addons
B2
Addons
Bus 02
Ports on Bus
Port 0201
Channels
B1
Addons
Partial Double Density bus Double Density bus