Nortel BCM 3.7, Manual

Page: 299 / 1004

Assigning target lines 299
Programming Operations Guide
8
Repeat steps 3 to 7 for all the DNs you want to assign with target lines.
Configuring the target line received number
Configure the numbers that the system uses to identify the destination for the target line.
1
Click the keys beside Services, Telephony Services, Lines, Target Lines .
2 Click the Line XXX you want to set.
3
Click the key beside Trunk/line data .
Note: For Trunk/line data programming, refer to “Target lines and DASS2 fields” on page
259 .
4 Click on Received number . Refer to “Notes about the Public and Private Received Numbers”
on page 300 for details.
Figure 84 Defining a Received number
5
Press < Tab > to save the changes.
6
Program the General , and Telco features as you would for any other line. Refer to “Target
lines and DASS2 fields” on page 259 .
7
Repeat steps 2 to 6 for all the target lines you want to configure.
Caution: Changing the received # length:
If you change the received number length for your system, the Public number entry for
the target lines will clear if the new received # length is less than the number entered in this
field.
If the new received # length has more digits than the number entered in this field, you need
to change the entry manually, if changes are required. Refer to
“Changing the received #
length” on page 296 .