Nortel BCM 3.7, Manual

Page: 588 / 1004

588 Feature operation within Hunt groups
N0008589 3.3
Feature operation within Hunt groups
The operation of some features varies if the Business Communications Manager telephone is part
of a Hunt group. The following table shows the affected features.
Table 134 Hunt group feature operation
Feature Description
Call Forward All Calls The system ignores Call Forward All Calls feature and the Hunt group call
rings at the telephone.
Call Forward No Answer The system ignores Call Forward No Answer and the Hunt group call
continues to ring until the hunt time expires.
Call Forward on Busy The system ignores Call Forward on Busy and the Hunt group call continues
to ring until the hunt time expires.
Do not Disturb on Busy If this feature is active, the set will not receive notification of incoming Hunt
group calls.
Group Pickup If a set is part of a Hunt group and a call pickup group, then an incoming Hunt
group call can be picked up from any set that is in the call pickup group.
Transfer via Hold The system supports transfer for Hunt group sets. However, you cannot
Transfer via Hold. Once you answer a call on a Hunt group set, its appearance
disappears from all other sets in the Hunt group. This means that other calls
can come in on the same line.
Priority Call You cannot make Priority calls to Hunt group DNs.
Ring Again You cannot use Ring Again when calling a Hunt group DN.
Line Redirection The Allow redirect attribute should be set to N for lines assigned to Hunt
groups. For more information, see
“Defining device capabilities” on page 417 .
Page Zones You cannot include Hunt group DNs in a Page zone.
Voice Call Hunt groups cannot accept voice calls. Answer buttons have no appearances
for voice calls, and the set does not ring.