Nortel BCM 3.7, Manual

Page: 160 / 1004

160 Working with the modules
N0008589 3.3
5
Click the OK button.
Programming reminder: If your system has a 3/5 DS30 split, bus 07 will not have a module
assigned to it.
Disabling/enabling a port channel setting
If you need to isolate a problem or block access from the module, you may need to turn off
individual port channels, rather than the entire module.
To turn off a channel:
1 Click on the keys beside Resources , Media Bay Modules, and beside the Bus number where
the module is located.
2 Click the key beside Ports on bus .
3
Click the key beside the port that contains the channel you want to disable.
4 Click the key beside Channels .
5
Click on the B channel you want to disable ( B1 or B2 ).
6 On the top menu, click Configuration and select Disable or Enable .
If you are disabling the channel, you will be prompted by a dialog box to confirm your action.
The
State field indicates the mode of operation for the port, as shown in the figure below. If
the port is enabled, this field is blank unless a device is physically connected.
Figure 43 Warning: This will disable the port