Nortel BCM 3.7, Manual

Page: 286 / 1004

286 Provisioning the loop variables
N0008589 3.3
Provisioning the lines
Once you provision the loop, two numbers are assigned to the loop. These also need to be
separately provisioned.
1
Click the keys beside Resources , Media Bay Modules , Bus 0X , Modules on bus , Module X ,
Provision loops, Loop XXX, Lines on Loop.
where Bus 0X is the bus to which the BRI module is configured; Module X is the offset (1, 2,
or 3) to which the BRI module was set, and Loop XXX is the BRI loop that you specified as a
trunk loop (T).
2 Click on Line XXX .
3
Beside the Status field, select Provisioned from the drop down list.
Figure 73 Provisioning BRI loop lines
4
Click outside the Bus 0X-Module X-Loop XXX window to invoke the change of status.
5 Repeat for second line, if there is one.
6
Make a note of the line numbers.