Nortel BCM 3.7, Manual

Page: 602 / 1004

602 Using the Hospitality services room telephone
N0008589 3.3
Using the Hospitality services room telephone
The room telephones can be used by cleaning staff and guests to set alarms and room states. This
section describes these codes and the process for using them.
• “Setting the alarm on a room telephone” on page 602
• “Setting the Room condition” on page 604
Setting the alarm on a room telephone
Guests can set alarms, turn them off and cancel them from their room telephones. The following
section describes this process for both digital telephones and analog telephones, or telephones
attached to the system using an ATA device.
This section also describes how to:
• “Change or cancel an alarm time” on page 603
• “Turn off an alarm” on page 603
To set the Alarm time feature on a telephone:
1
Press FEATURE 875 .
The display shows Alrm: 07:00am OFF.
2
If the alarm time is correct press
ON
.
The display shows
Alrm:07:00am ON
.
3
Press
DONE
to exit.
To change the alarm time on a telephone:
1 Press FEATURE 875 .
The display shows Alrm: 07:00am OFF.
2 To enter a new alarm time press
CHG
.
The display shows
Enter time:
.
3 Enter a new four-digit alarm time.
4
Press
ON
.
5 Press
DONE
to exit.
When using the 24-hour clock format (hour: 00 to 23 and minutes: 00 to 59), no confirmation
is required. The display shows
Alarm ON hh:mm
.
When using the 12-hour format, the display shows
hh:mm AM or PM?
. Press the
AM
or
PM
display button. The display shows
Alarm ON hh:mm
.