Nortel BCM 3.7, Manual

Page: 311 / 1004

311
Programming Operations Guide
Chapter 12
Configuring outgoing calls
This section describes how you can configure the lines and loops to allow system users to dial out
of the system over a public or private network.
The following figure shows the position of the headings in the Unified Manager for the
information covered in this chapter.
Figure 87 Unified manager telephony services headings
Task:
• Understand what dialing plan is being used for the public and private networks
( “Configuring the public and private dialing plans” on page 312 )
• Set up call controls, when required, such as CbC limits
( “Configuring Call by Call services” on page 350 )
• Set up access codes, routes, and destination codes
( “Programming access codes” on page 321 , “Understanding access codes” on page 320 ,
“Configuring call routing” on page 331 )
• Set up restriction filters, as required ( “Defining restriction filters” on page 356 )
Telephony Services
. . .
Restriction Filters
Filter 00-99
Restrictions
Restriction 01-XX
Overrides
Call Routing
Routes
Route XXX
Destination Codes
XXX
Schedules
Normal
Night
Evening
Lunch
Sched 4
Sched 5
Sched 6
General Settings
Feature Settings
Nortel IP Terminals
IP trunking
Timers
Direct dial
CAP/KIM Assignments
Dialing Plan
Dialing timeout
Private Network
Public Network
Public DN lengths
Prefix Default
Prefix <XX>
General Settings ...
Access Codes
Park Prefix
External code
Direct Dial Digit
Auto DN
DISA DN
Private access code
Local access code
National access code
Special access code
Line Pool Codes
Carrier Codes
Remote Access Packages
COS Passwords
DN lengths
CbC Limits
Release Reasons
Network Services
Silent Monitor