Nortel BCM 3.7, Manual, Page: 424 / 1004

424 Determining analog settings
N0008589 3.3
Determining analog settings
The settings for analog devices under Capabilities allow you to define general settings for
equipment connected to an analog media bay module or through an Analog Terminal Adaptor
(ATA2), which connects an analog device to a digital media bay module (DSM). These settings
apply to analog DNs only and are available to telephone DNs in the digital telephone range with
Model set to Other .
Details about how to use an analog telephone are included in the Analog Telephone User Guide .
Follow these steps to configure the ATA settings:
1
If you are not already in the DN record, click the key beside the telephone DN to which you
want to assign ATA settings to.
2
Click on the key beside Capabilities .
3 Click on ATA settings .
The ATA settings screen appears for that DN.
Figure 135 ATA settings for a DN
4 Use the information in the following table to configure ATA settings.
Table 83 ATA settings
Attribute Values Description
ATA answer
timer 3, 5, 7, 10 Select the length of delay between the last digit you dial and when the ATA 2 device
is ready to receive DTMF tone.
ATA tones N, Y N: No tones occur when a message is received (use for data equipment).
Y: Tones occur when a message is received (use for analog telephones).
ATA use On site
Off site
Select the location of the ATA 2.
Note: Set the field to Onsite for all installations except devices on a long loop. Set
the field to Offsite to increase the audio level to devices that are remote to the
ATA2. This field has no effect for ASM and GASM devices.
Msg Indicate None
Tone
Lamp
Tone sends a Message Tone through the telephone receiver when you receive a
message.
Lamp turns on the Message Lamp when you receive a message. (Refer to
“MWI
tone/lamp matrix” on page 425 .)