Nortel BCM 3.7, Manual

Page: 344 / 1004

344 Configuring destination codes with wild cards
N0008589 3.3
Enable/disable wild card digits
1 Click on the key beside Wild cards .
The valid numbers for the wild card for
this code are displayed.
2
Click on the number you want to change.
3 In the Wild card state field, choose
Assigned (can be used with this
destination code) or Available (can be
used as part of another destination code).
4 Repeat steps 2 and 3 for all the numbers
you want to change.
Setting up a destination for local
calling
An office can have different suppliers for
local and long distance telephone service. By
programming a destination code, any call that begins with 9, which is the most common dial out
digit, automatically uses lines dedicated to local service.
Note: 9 is the default setting for the line pool code for Pool A. If you want to use 9 as a destination
code, you must change the Pool A code. Refer to “Assigning line pool access” on page 414 .
Follow these steps to build a route to allow local calls.
1 Create a route that uses the line pool you assigned for the PSTN trunks. ( “Defining routes” on
page 333 ).
2 Create a destination code record and enter a destination code, such as 9, which is a common
local call code. (
“Configuring destination codes with wild cards” on page 342 )
For local calls only, there are no dial out numbers (compare with “Setting up a route through a
dedicated trunk” on page 345 ).
The destination code can use a different route, depending on what schedule is assigned. In the
current example, the route you define is used when someone dials 9 during Normal mode,
when the other Schedules are turned off.
3
Set up the Normal schedule with the route number you defined in step 1.