Nortel BCM 3.7, Manual

Page: 174 / 1004

174 Universal T1 WAN (UTWAN)
N0008589 3.3
Removing a line assigned for data traffic
If you decide you want to stop using a line for data traffic and use it as a telephony line, use the
procedures below:
Removing the line from the Data Module
1 Click the Resources key and click the Media Bay Modules key.
2 Click the key beside the Bus number assigned to the Data Module.
3 Click the Data module key and click the Interfaces key.
4 Click the key beside the Interface number from which you want to remove the line assignment.
5 Click the Line assignment key.
6 Click on the line number you want to remove.
7 Click the Delete button.
8 On the confirmation dialog box, click the Yes button.
Configuring the line for telephony traffic
1 Click the Services key and click the Telephony Services key.
2
Click the Lines key and click the Physical lines key.
3 Click the All physical lines key.
4 Click the key of the line number you want to assign to telephony use.
5 Click the Trunk/line data heading.
6 Click the Trunk type drop list and then click on the correct type of trunk.
7 Configure the line in the same manner as you configure other telephony lines. For information
about how to configure digital lines, refer to
“Provisioning lines (PRI, T1, DASS2)” on page
152 .