Nortel BCM 3.7, Manual

Page: 285 / 1004

Provisioning the loop variables 285
Programming Operations Guide
Figure 71 Add a TEI to the D-packet service
Provisioning the loop variables
When you assign a BRI loop as a trunk loop, you need to return to the media bay module settings
and provision the loop, and the lines assigned to the loop. Once the loop is provisioned, it displays
the two line numbers that are assigned to the loop, these also need to be provisioned.
Once the lines are provisioned, you can configure them in the same way as you would other lines.
Refer to
“Programming BRI lines” on page 287 .
Provisioning the Loop
1 Click the keys beside Resources , Media Bay Modules , Bus 0X , Modules on bus , Module X ,
Provision loops
where Bus 0X is the bus to which the BRI module is configured; Module X is the offset (1, 2,
or 3) to which the BRI module was set.
2 Click on Loop XXX .
Loop XXX is the BRI loop that you specified as a trunk loop (T)
3 Beside the Status field, select Provisioned from the drop down list.
4
Click outside the Bus 0X-Module X-Loop XXX window to invoke the change of status.
Figure 72 Provisioning BRI loops
5
Click the key beside Loop XXX twice to close and then reopen the heading.