1-37
基本操作
BASIC OVERVIEW
<プリセッタ測定補助モード中の注意事項>
<Cautions on Operations in the Presetter Measurement
Sub Mode>
1.
手動軸送りオーバライドは、
52 mm/min
に固定されます。
2.
軸が停止している状態で手動軸送りボタ
ンを
1
回押すと、軸が
5 mm
移動します。
軸移動を停止させるには、
(リセッ
ト)キーを押し、プリセッタ測定補助
モードをキャンセルしてください。
5 mm
移動してもスタイラスに接触しなかった
場合、
PC
アラーム
"EX4917
プリセッタ
センサに接触していません
"
が表示され
ます。
(リセット)キーを押し、ア
ラームを解除してから〔プリセッタモー
ド〕
ボタンをオンし、再度手動軸送り
ボタンを押してください。
3.
一方向移動中に、他の方向の手動軸送り
ボタンを押しても、移動方向は変わりま
せん。
4.
一方向移動中に、同じ方向の手動軸送り
ボタンを押し続けた場合は、通常のジョ
グ送りと同様にボタンを押している間だ
け軸移動し、ボタンから手を離すと軸移
動が停止します。
1.
Manual axis feedrate is fixed at 52 mm/min.
2.
When the axis feed button is pressed once while
the axis is stopped, the axis moves
5 mm. To stop the axis movement, press the
(RESET)
key to cancel the presetter measure-
ment sub mode. If the tool does not touch the
stylus even if the axis is moved 5 mm, the PC
alarm "EX4917 TOOL DOESN'T TOUCH ON
THE SENSOR" is displayed. Release the alarm
by pressing the
(RESET)
key before pressing
the
[Presetter Mode]
button and press the
axis feed button again.
3.
In uni-directional axis movement in the presetter
measurement sub mode, the axis movement
direction is not changed even if the axis feed but-
ton of the other axis feed direction is pressed.
4.
In uni-directional axis movement in the presetter
measurement sub mode, if the axis feed button of
the same axis feed direction is held down, the
axis moves while the switch is being held down
and stops when it is released, as in normal jog
feed operation.
RESET
RESET
Summary of Contents for MSX-850
Page 54: ...1 CHAPTER 1 BASIC OVERVIEW...
Page 170: ...2 CHAPTER 2 MACHINE OPERATIONS...