Matrix SPARSH VP710, User Manual, Page: 837 / 1046

Matrix SPARSH VP710 User Guide 829
Description
Configures the volume of the speaker when
receiving the multicast paging calls.
If it is set to 0, the current volume of the speaker
takes effect. The volume of the speaker can be
adjusted by pressing the Volume key in advance
when the phone is during a call.
You can also adjust the volume of the speaker
during the paging call.
If it is set to 1 to 15, the configured volume takes
effect and the current volume of the speaker will be
ignored. You are not allowed to adjust the volume
of the speaker during the paging call.
Default Value 0
Range Integer from 0 to 15
Example multicast.listen_address.1.volume = 1
Parameter
-
multicast.receive.use_speaker
Configuration File
<MAC>.cfg
Description
Enables or disables the IP phone to always use the
speaker as the audio device when receiving the
multicast paging calls.
If it is set to 0 (Disabled), the engaged audio device
will be used when receiving the multicast paging
calls.
Default Value 0
Range
0-Disabled
1-Enabled
Example multicast.receive.use_speaker= 0
Parameter
-
multicast.receive_priority.enable
Configuration File
<MAC>.cfg
Description
Enables or disables the IP phone to handle the
incoming multicast paging calls when there is an
active multicast paging call on the IP phone.
If it is set to 0 (Disabled), the IP phone will ignore
the incoming multicast paging calls when there is an
active multicast paging call on the IP phone.
If it is set to 1 (Enabled), the IP phone will receive
the incoming multicast paging call with a higher or
equal priority and ignore that with a lower priority.
Default Value 1