Matrix SPARSH VP710, User Manual

Page: 510 / 1046

502 Matrix SPARSH VP710 User Guide
• The variable value is not applicable to all the events. For example, for an IP phone the variable value
“MUTE” is only applicable during a call.
• When authentication is required, you must enter
“p=login&q=login&username=xxx&pwd=yyy&jumpto=URI&” before the variable “key”. xxx refers to the
login user name and yyy refers to the login password.
Matrix IP phones also support a combination of the variable values in the URI, but the order of the variable value is
determined by the operation of the phone.
The valid URI format is:
http(s)://<phoneIPAddress>/servlet?key=variable value[;variable value] . Variable values
are separated by a semicolon from each other.
The following shows an example for answering an incoming call then mute the call immediately:
http://10.3.20.10/servlet?key=ASW;MUTE.
Configuring Trusted IP Address for Action URI
By default, the IP phone do not handle HTTP/HTTPS GET requests for security reasons. For action URI you need
to specify the trusted IP address. When the IP phone receives a GET request from the trusted IP address for the
first time, the touch screen prompts the message “Allow Remote Control?”. You can specify one or more trusted IP
addresses on the IP phone, or configure the IP phone to receive and handle the URI from any IP address.
If you are using SIP NOTIFY message method, you do not need to specify the trusted IP address for action URI.
But you should enable the IP phone to receive the action URI requests. When the IP phone receives a SIP NOTIFY
message with the “Event: ACTION-URI” header from a SIP proxy server for the first time, the touch screen also
prompts the message “Allow remote control?”.
You can use action URI feature to capture the phone’s current screen. For more information, refer to “Scenario A -
Capturing the Current Screen of the Phone”.
phonecfg=get[&accounts=x][&dnd=x
][&fw=x
Get firmware version, registration, DND or forward
configuration information.
The valid value of “x” is 0 or 1, 0 means you do not need to get
configuration information. 1 means you want to get
configuration information.
Note: The valid URI is:
http(s)://<phoneIPAddress>/servlet?phonecfg
=get[&accounts=x][&dnd=x][&fw=x]
Example:
http://10.10.20.10/servlet?phonecfg=get[&acc
ounts=1][&dnd=0][&fw=1]