Avaya S8700 Series, Maintenance Manual

Page: 1847 / 2618

MMI-PT
Issue 1 May 2002 8-1125 555-233-143
Error Log Entries and Test to Clear Values
Notes:
a. The customer endpoint connected on a conference sent too many
messages to the VSP-MCU in a specified amount of time. Check the
“status conference” forms to correlate which customer had the problem.
This is a customer endpoint problem and not a VSP-MCU problem.
b. This port has been busied out by the busyout port UUCSSpp command.
c. Indicates that the circuit pack has been removed or has been insane for
more than 11 minutes. To clear the error, replace or reseat the circuit pack.
d. This error occurs if the MMI circuit pack detects a DSP Error. Maintenance
software will reset the DSP when this error is received. This error is logged
for all 8 resources connected to this particular DSP. If this DSP continues
to fail sanity, a Minor alarm is raised. Replace the circuit pack.
e. This error occurs when the Resource Loop-around test (#1111) fails. Run
the long test sequence, and note the results of Test #1111.
Table 8-463. MMI-PT Error Log Entries
Error
Type Aux
Data
Associated Test
Alarm
Level On/Off
Board
Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test’s description, and follow its recommended procedures.
0 Any Any Any test port UUCSSpp sh r 1
1 (a) Any Uplink error from pack
18 (b) 0 Busyout port PCSSpp WARNING OFF release port UUCSSpp
130 (c) Any Software generated WARNING ON
257 (d) Any None MAJOR
MINOR ON
513 (e) Any Resource Loop-Back
test (#1111) MINOR ON test port UUCSSpp sh r 3
1025 (f) Any Uplink error from pack
3841 –
3844 (g) Any Uplink error from pack