Avaya S8700 Series, Maintenance Manual

Page: 1957 / 2618

PKT-BUS (Packet Bus)
Issue 1 May 2002 8-1235 555-233-143
Table 8-505. Test #572 Maintenance/Test Circuit Pack Query Test
Error
Code Test
Result
Description / Recommendation
1006 ABORT The packet bus port of the Maintenance/Test circuit pack is out of service.
1. Determine whether the port is busied out. If so, release it with the release
port UUCSS04 command. Then retry the test command.
2. If there are alarms active against the packet bus port (MT-PKT), see
‘‘M/T-PKT (Maintenance/Test Packet Bus Port)’’ to resolve them. Then
retry the test command.
1142 ABORT No Maintenance/Test circuit pack packet bus port is in service in this PN.
1. If this PN is required by configuration guidelines to have a
Maintenance/Test circuit pack:
a. the Maintenance/Test circuit pack for this PN has failed, and should be
replaced,
b. the Maintenance/Test circuit pack has been busied out, and should be
released, or
c. there is no Maintenance/Test circuit pack in thisPN, and one must be
installed.
2. In an PN of a system without PNC duplication, the Maintenance/Test
packet bus Port is not required and may not be present. If it is present, and
is busied out, or has failed, release or replace the circuit pack. If there is
no Maintenance/Test circuit pack, ignore the results of this test for this PN.
2000 ABORT The test timed-out while waiting for an uplink CCMS response from the
Maintenance/Test packet bus port.
1. Re-enter the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, check for problems with the Maintenance/Test
packet bus port (look for M/T-PKT in the Error and Alarm Logs).
2059 ABORT The Maintenance/Test packet bus port has reported a hardware failure.
1. See ‘‘M/T-PKT (Maintenance/Test Packet Bus Port)’’ to correct the
problem.
2. Re-enter the test command.
Continued on next page