Avaya S8700 Series, Maintenance Manual

Page: 152 / 2618

Alarms, Errors, and Troubleshooting
555-233-143 4-78 Issue 1 May 2002
Asynchronous Method
The asynchronous method requires a Maintenance/Test circuit pack to be present
in the system. In this method, 4 commands are used to start, stop, list, and query
an outgoing ISDN-PRI test call:
Before placing an outgoing ISDN-PRI test call, verify that the feature access code
has been administered on the System Features form, and that the far-end test line
number and TestCall Bearer Capability Class (BCC) have been administered on
the Trunk Group Administration form. Furthermore, if the ISDN-PRI trunk is the
cbc (call by call) service type, then the
Testcall Service
field on the Trunk
Group Administration form must have been administered also.
To initiate an outgoing ISDN-PRI test call with the asynchronous method, issue
the start command listed above, which enables you to specify a specific the trunk
on which to originate the ISDN-PRI test call. An optional qualifier can be used
that specifies in minutes (1 to 120) the duration of the test call. If no duration is
specified, the default is either 8.4 or 9.6 seconds.
Screen 4-1 shows a typical response to the test isdn-testcall command:
Screen 4-1. Test ISDN-TestCall Response
The displayed fields have the following meanings:
Start: test isdn-testcall grp/mbr [minutes]
Stop: clear isdn-testcall grp/mbr
List: list isdn-testcall
Query: status isdn-testcall grp/mbr
Port
The port address (UUCSSpp) is the port network’s number, carrier designation,
slot, and circuit of the maintenance object (MO) under test.
Maint. Name
The type of MO tested.
Test Number
The actual test that was run.
Test
Results
Indicates whether the test passes, fails, or aborts.
Error Code
Additional information about the results of the test. See the ISDN-TRK section
in Chapter 9 for details.
test isdn-testcall
Port Maintenance Name Test Number Test Result Error Code
1B1501 ISDN-TRK 258 PASS