Avaya S8700 Series, Maintenance Manual

Page: 230 / 2618

Additional Maintenance Procedures
555-233-143 5-44 Issue 1 May 2002
Output Fields—ATMS Detail Report
Measurements are made in both directions, near to far end, and far to near end.
For each measurement, there are two columns on the lower part of the report,
“NE” for near end, and “FE” for far end. These refer to the destination end for that
measurement.
Group
The trunk-group number selected
Type
The trunk-group type
Vendor
The vendor of this trunk group
TTL Type
The type of terminating test line on the switch at the far end of the trunk to which
the test call was made
Threshold
Values
The list of marginal and unacceptable threshold values for each type of
measurement as defined on the Trunk Group form
Trk Mem
The trunk-group member number
Test Date
The month and day this trunk was last tested
Test Time
The time of day this trunk was last tested
Tst Rslt
The results of the trunk transmission test as follows:
pass
The test call completed successfully and trunk performance was satisfactory.
marg
Trunk measurements exceeded the marginal threshold, but not the unacceptable.
fail
Trunk measurements exceeded the unacceptable threshold.
xxxx
A numerical error code indicates the reason for an aborted test call. The codes
are explained in the CO-TRK and TIE-TRK sections of
‘‘ABRI-PORT (ASAI
ISDN-BRI Port)’’ on page 8-3 .
blank
A blank line indicates that no measurements have been made on this trunk since
the database was last initialized.
1004Hz-loss
Min
Far-to-near and near-to-far measurements of 1004-Hz loss from low-level tone.
1004Hz-loss
Max
Far-to-near and near-to-far measurements of 1004-Hz loss at 0 dBm.
Loss dev at
404Hz
These low-frequency transmission tests measure maximum positive and negative
deviation of +9 and -9 dB from the 1004-Hz loss measurements.
Loss dev at
2804Hz
These high-frequency transmission tests measure maximum positive and
negative deviation of +9 and -9 dB from the 1004-Hz loss measurements.
C-msg Noise
Maximum interference noise on a voice terminal within the voice-band frequency
range (500 to 2500 Hz). The measurement ranges from 15 to 55 dBrnC (decibels
above reference noise).
C-ntch Noise
Maximum signal-dependent noise interference on a line between 34 and 74
dBrnC.