Freescale Semiconductor MPC5565, Справочное руководство

Страница: 884 / 1153

Deserial Serial Peripheral Interface (DSPI)
MPC5565 Microcontroller Reference Manual, Rev. 1.0
Freescale Semiconductor 19-61
Figure 19-36 shows the timing diagram for two four-bit transfers with CPHA = 1 and CONT = 0.
Figure 19-36. Example of Non-Continuous Format (CPHA = 1, CONT = 0)
When the CONT = 1 and the PCS signal for the next transfer is the same as for the current transfer, the
PCS signal remains asserted for the duration of the two transfers. The delay between transfers (t
DT
) is not
inserted between the transfers.
Figure 19-37 shows the timing diagram for two 4-bit transfers with CPHA = 1 and CONT = 1.
Figure 19-37. Example of Continuous Transfer (CPHA = 1, CONT = 1)
In Figure 19-37 , the period length at the start of the next transfer is the sum of t
ASC
and t
CSC
; i.e., it does
not include a half-clock period. The default settings for these provide a total of four system clocks. In many
situations, t
ASC
and t
CSC
must be increased if a full half-clock period is required.
Switching CTARs between frames while using continuous selection can cause errors in the transfer. The
PCS signal must be negated before CTAR is switched.
When the CONT bit = 1 and the PCS signals for the next transfer are different from the present transfer,
the PCS signals behave as if the CONT bit was not set.
SCK
(CPOL = 0)
PCSx
t
ASC
SCK
(CPOL = 1)
Master SOUT
t
DT
t
CSC
t
CSC
= PCS to SCK delay.
t
ASC
= After SCK delay.
t
DT
= Delay after transfer (minimum CS negation time).
Master SIN
t
CSC
SCK
(CPOL = 0)
PCS
t
ASC
SCK
(CPOL = 1)
Master SOUT
t
CSC
t
CSC
t
CSC
= PCS to SCK delay.
t
ASC
= After SCK delay.
Master SIN