EXFO Power Blazer 88200NGE, User Manual

Page: 548 / 887

Test Results
538
88000 Series
Summary / Client Summary

Local/Remote direction buttons are available for single/dual port
topology in
One-Way
measurement mode.
Note:
Throughput (including RX Frame Count , TX Rate , and TX Frame Count ),
Jitter , Latency , and Frame Loos/Out-of-Sequence are available when
enabled (see QoS Thresholds ) but their availability depend on the selected
measurement mode, measurement role, and direction.

Throughput , Jitter , and Latency meters display respectively the
measured Throughput, Jitter, and Latency.
Note:
The green region defined by the configured threshold corresponds to a
PASS verdict while the red regions corresponds to a FAIL verdict. The
Pass/Fail verdict is only displayed when enabled (see QoS Thresholds on
page 182).

Jitter is the delay variation measured
1
on all valid frames
2
received.
Current
,
Average
,
Minimum
,
Maximum
, and
Estimate
delay values
are reported in μ s per direction when applicable.

Latency
is measured
1
on all valid frames
2
received.
Current
,
Average
,
Minimum , and Maximum latency (delay) are reported.
For
One-Way
and
One-Way P<m>

P<n>
measurement modes,
indicates the measured one-way latency (delay) in μ s per direction
when applicable (available on the sender side).
For Round-Trip measurement mode, indicates the measured
round-trip latency (delay) in
μ s (available on the sender side).

Throughput is the RX rate value measured on all valid frames (no FCS
and UDP Checksum errors).
Current
,
Average
,
Minimum
, and
Maximum throughput results are reported. A Current value of 0
indicates that no throughput has been measured in the last second.
1. Measurements smaller than 1 μ s will be discarded, not used for the sampling process, and
< 0.001
will be displayed
as the minimum value. For the Current value,
Not measurable
is displayed when no delay has been measured in the
last second.
2. Frames with One-Way Delay (OWD) messages and no FCS and UDP Checksum errors.