EXFO Power Blazer 88200NGE, User Manual

Page: 170 / 887

Test Setup - Test Configurator, Timer, and System
160
88000 Series
BERT and Unframed BERT
Note: The Service Disruption Time measurement supports a parent defect
approach where the SDT measurement is triggered when the selected
defect or a higher defect in the signal structure hierarchy is detected. For
example, if Bit Error is selected, an OPU AIS error will trigger an SDT event.

No Defect Time (ms) represents the period without any defects before
stopping SDT measurement:
0.005 ms
to
2000 ms
(default is
300 ms
).

Disruption Monitoring check box when selected (disabled by
default) enables the disruption time measurements. However, the
measurement will only start if the test is already started, or when the
test will be started.
Note: Clearing the Disruption Monitoring check box will stop the measurement
without clearing the results. The disruption monitoring is automatically
stopped without clearing results when the test is stopped. However, starting
the test again while the
Disruption Monitoring check box is selected will
reset the results before restarting.

Pass/Fail Verdict
check box when selected (cleared by default)
enables service disruption pass/fail verdict and allows setting the
threshold value.

SDT Threshold (ms) allows entering the SDT threshold value that will
be used to declare the pass/fail verdict:
0.001
to
299999.999 ms
(default is 50 ms). For EtherBERT, the minimum value is adjusted with
respect to the
No Traffic Time
.
Multi-Pattern Configuration
Note:
Only available for DSN/PDH BERT test application with DS1 signal (DS0
disabled) and when the pattern is Multi-Pattern .
This feature allows sending each pattern for a specific duration,
sequentially and continuously.