EXFO Power Blazer 88200NGE, User Manual

Page: 313 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
303
RFC 6349
RFC 6349
From the
Test
menu, tap
Setup
,
Test Configurator
, and the RFC 6349
block.
Connection

Operation Mode allows the selection of the test operation mode: Dual
Test Set
(
DTS
) or
EXFO|Worx Interop
.
The connection is graphically displayed with its status as follows:
Operation
Mode
Status Description
Dual Test Set Disconnected No connection established with a remote module.
NAT
LAN/WAN ,
WAN IP
Connection established with a remote module.
NAT LAN/WAN and WAN IP indicate presence of NAT
(Network Address Translation) router. The NAT router is
automatically detected and graphically displayed with
LAN/WAN indication as well as the WAN IP address
when the Power Blazer is behind a NAT router.
When there is a NAT at the Remote site, it is required to
create the following rules on this NAT router:
1- for UDP/TCP port 62819 to allow DTS
communication.
2- for the defined TCP port (see TCP Port on page 304).
EXFO|Worx
Interop Disconnected Verifier not detected (not reachable, invalid IP, or invalid
TCP port).
Ready or
Running Verifier detected, either running (remote unit locked) or
ready to perform a test.
The detection of NAT (Network Address Translation)
router presence is automatically detected and
graphically displayed. The WAN IP address is also
displayed when the module is behind a NAT router.
Busy Verifier busy with another client (locked).