EXFO Power Blazer 88200NGE, User Manual

Page: 193 / 887

Test Setup - Test Configurator, Timer, and System
Power Blazer
183
EtherBERT, FC BERT, BERT (eCPRI, CPRI/OBSAI, and FlexE), and Unframed BERT
EtherBERT, FC BERT, BERT (eCPRI, CPRI/OBSAI,
and FlexE), and Unframed BERT
Note: For EtherBERT unframed test 40/100/200/400GE, refer to BERT and
Unframed BERT
on page 155.
From the Test menu, tap Setup , Test Configurator and tap on the
EtherBERT
,
Clients
>
BERT
,
FC BERT
,
BERT
, or
Unframed BERT
block.
LINK
Note:
Available with OTN BERT test application with Ethernet client (EoOTN).
A green/red arrow is used to indicate the status of the link at the PCS level:

A green arrow indicates that the link is up.

A red arrow indicates alarms at the PCS level, the link is down.
The
Local Fault Detected
,
Local Fault Received
,
Remote Fault
,
LOA (OTU4), Hi-BER (OTU4), LOBL1027B (OTU3), Hi-BER1027B (OTU3),
and
LOAML1027B
(OTU3) alarms are displayed. Refer to
Ethernet
on
page 405, Ethernet - PCS Lanes on page 410, and Transcoding on page 465
for more information.
Restore < Test Application > Defaults
Reverts the current test application to its default factory settings. Available
with OTN BERT test application with Ethernet client (EoOTN), and
CPRI/OBSAI BERT.
Pattern on Client ID
Selects the Client ID on which the pattern is applied. The pattern applies to
a single client only. Only available with FlexE BERT test application.