EXFO Power Blazer 88200NGE, User Manual

Page: 270 / 887

Test Setup - Test Configurator, Timer, and System
260
88000 Series
MAC/IP/UDP
The following configuration parameters are available for both IPv4 and
IPv6
unless otherwise specified.

Quick Ping button automatically starts the quick Ping utility for the
stream destination IP address and provides either a successful or failed
result. The quick Ping uses 3 attempts, a Delay of 1 second, a Timeout
of 2 seconds, and a Data Size of 32 Bytes. Refer to
Ping & Trace Route
on page 686 for more options.

Resolve MAC Address
check box, when selected (default), sends a
request to the network to retrieve the MAC address corresponding to
the selected destination IP address. This setting is coupled with the
Resolve MAC Address check box from
MAC on page 253. The Resolve
MAC address status is displayed. Possible status are:

Source IP Multiplicator
check box, when selected (cleared by
default), allows changing the 7 LSB (Least Significant bit) of the source
IP address as specified in the range:
1-128
(default) or
0-127
. Not
available with eCPRI.

Subnet Mask
(IPv4) allows entering the Subnet Mask for the stream.
The default setting is 255.255.0.0 . Not available when the Automatic IP
(DHCP)
check box is selected.

Default Gateway (IPv4) check box, when selected (cleared by
default), allows entering a default Gateway IP address. When the
Default Gateway check box is selected, its default address is 0.0.0.0 .
The
Default Gateway
address is not configurable when the
Automatic
IP (DHCP) check box is selected.
Status Description
-- The Resolve MAC address is not enabled.
Resolving The MAC address is being resolved.
Resolved The MAC address is resolved.
Failed The MAC address cannot be resolved.