EXFO Power Blazer 88200NGE, User Manual

Page: 264 / 887

Test Setup - Test Configurator, Timer, and System
254
88000 Series
MAC/IP/UDP
Note: Depending on the Layer Mode (available with EtherSAM), some EtherType
require to set the configuration parameters through the Modify Frame
Structure pop-up instead of configuring its value from this field; in this case
a pop-up message is displayed indicating the reason. The following
EtherType are not supported for
Mixed layer mode: 0x0001 to 0x05FF and
0x8870.

OUI , available when the frame format 802.3 SNAP is selected, allows
the selection of the Organizationally Unique Identifier (OUI):
RFC1042 (0x000000) - (default)
User Defined
, available when
Network Layer
is set to
None
, allows
entering the OUI value: 0x000000 (default) to 0xFFFFFF .
Note:
Source/Destination Flooding and Flood Range are only available with
Traffic Gen & Mon when the Network Layer is set to None (see page 249).

Source Flooding
and
Destination Flooding
check boxes when
selected (cleared by default) allows generation of frames using
source/destination MAC addresses flooding as follows: The first frame
is transmitted starting with the least significant bits of the
source/destination MAC address covered by the range set to 0; each
subsequent frame is transmitted by incrementing the least significant
bits by 1; when the upper limit of the range is reached, the
source/destination MAC address restarts over with the least significant
bits covered by the range set to 0.

Flood Range is the range of the least significant bits used for the
Source Flooding and/or Destination Flooding:
2 (1 bit)
,
4 (2 bits)
,
8 (3 bits) , 16 (4 bits) ... up to 16777216 (24 bits) (default).