EXFO Power Blazer 88200NGE, User Manual

Page: 232 / 887

Test Setup - Test Configurator, Timer, and System
222
88000 Series
GFP-F/GFP-T
GFP-F/GFP-T
Note: Only available with Ethernet 1GbE , 10GbE , or Ethernet (flex/GFP-F) client.
From the
Test
menu, tap
Setup
,
Test Configurator
, and tap on the
GFP-F/GFP-T block.
Note:
Refer to
Generic Framing Procedure (GFP)
on page 811 for more
information on Client Data and Client Management frames.

CDF pFCS
(Client Data Frames payload Frame Check Sequence)
enables the presence of the payload FCS for the client frames. This
setting is only available with
Ethernet (flex/GFP-F)
client.

CMF pFCS (Client Management Frames payload FCS) enables the
presence of the payload FCS for the management frames. The
CMF pFCS check box is automatically cleared when injecting FDI or
RDI alarms.

EXI (Extension Header Identifier) allows the selection of the type of
GFP Extension Header. Choices are
Null
(0000) - (Default) and
Linear (0001). EXI is only configurable with Ethernet (flex/GFP-F)
client.

CID (Channel IDentifier) selects the communication channel used for
the signal transmission f
or both Client Data and Client Management
frames . Choices are from 0 (default) through 255 . CID is only available
when EXI is set to
Linear
.
The status Mismatch is displayed next to the CID value when the TX
and RX CID values differ.

Delta indicates the GFP state machine synchronization parameter.
Delta is set to 1.