EXFO Power Blazer 88200NGE, User Manual

Page: 334 / 887

Test Setup - Test Configurator, Timer, and System
324
88000 Series
Services - Profile
Test Parameters
Note: Unit selection is available from the SLA Parameters on page 325.
For
Dual Test Set
, parameters are configurable for both local (
L
) and
remote ( R ) directions.
For
Dual Port
topology, parameters are configurable for both port
directions.

Traffic Policing
check box when selected (default) allows stressing
the rate limiting of the network by sending traffic at higher rate than
committed by the SLA.

Burst Max Rate allows setting the rate that is used for the CBS and EBS
burst tests. Only available when the
Burst Test
is enabled (see
EtherSAM - Global on page 193).
Note:
Changing a criteria value (CIR, CIR+EIR, Ramp Traffic Policing, or Burst
Max Rate) may affect the other criteria values in order to comply to the
following rules:
CIR

CIR+EIR

Ramp Traffic Policing Rate

Line Rate
CIR

CIR+EIR

Burst Max Rate

Line Rate
However, make sure that the criteria values comply to the following rule
with an adequate margin, as per ITU-T Y.1564 standard, for a burst test to
be valid:
CIR

CIR+EIR

Burst Max Rate

Line Rate