EXFO Power Blazer 88200NGE, User Manual

Page: 314 / 887

Test Setup - Test Configurator, Timer, and System
304
88000 Series
RFC 6349

Discover Remote button, available with Dual Test Set , allows
discovering remote modules supporting
Dual Test Set
. For more
details, refer to Discover Remote Button on page 718.

Direction
allows the selection of the traffic direction:
Local to Remote
,
Remote to Local , and Bidirectional (default).

Remote IP Address
, available with
EXFO|Worx Interop
, is either the
remote IP address of the verifier or the WAN IP address when the
verifier is behind a NAT router.

TCP Port is the port used by the server located at the remote side: 1 to
65535
(excluding
62819
that is used for DTS connection), default is
50201 . The port forwarding rule for the defined TCP port must be
created on the NAT router when the remote is behind a NAT.
Parameters

Multiple Connections
check box when selected (default) indicates
that the applicable TCP Throughput phases are performed with
multiple connections; otherwise TCP Throughput phases are
performed within a single connection. For 40/100GE rate, this check
box is selected and the
Window Size Target per Connection
can be
used to set the target window.

Window Size Target per Connection
, available for 40/100GE rate,
selects the target window per connection: 1 MiB, 4 MiB, 8 MiB, 16 MiB
(default), and 32 MiB.

CIR
The Local-to-Remote CIR and Remote-to-Local CIR represent the
Committed Information Rate of the Ethernet Service under test:
1.0 Mbit/s
to Line Rate. The CIR is not used to actually transmit frames
at this rate but to calculate a Bandwidth Delay Product (BDP) which in
turn is used to set the Max Window Size of the TCP connections.
Rate Unit determines the unit used to display the rate values:
Mbit/s
(default) or
Gbit/s
.