Philips CARDIOMD, Service Manual

Page: 141 / 466

Diagnostics
1MAN0158-H11 04-2005 CSIP Level 1
CardioMD Service Manual
„
5-37
Procedure Details
The HyperTerminal main window appears.
14. In the menu bar, select File , Properties .
The EDC Properties dialog appears.
15. Select the Settings tab.
16. In the Emulation drop-down list, select
VT100 and click OK.
HyperTerminal is now ready to communicate
with the EDC board.
To make the motion controller display its
->
prompt in the HyperTerminal main window:
17. Press [Enter].
18. This should cause the EDC prompt to
appear.
19. For further details, see section 5.6.2.3.
5.6.2.3 CardioMD EDC Command Definitions
The commands listed below are only accessible via the EDC board’s serial port labeled
A1 RS232. These commands can be useful when diagnosing system failures and intermittencies.
Note . The EDC interface only accepts numerical parameter(s) to commands. Parameters can be
entered either as decimal or hexadecimal values. Parameters shown in brackets {…} are optional.
Command List
? A help command that displays and provides a brief explanation of available
commands and utilities. It is useful when attempting to recall a specific
command and associated command flags.
Example:
?
STATUS Print status information
RDB Read byte from memory {Address}
. . .
VERSION Print version information
HELP, ? Print list of commands
Version Print the software version. The hardware part number printed with the
same command is just a comment and does not reflect the actual hardware
revision.