NXP Semiconductors MKW01Z128, Reference Manual, Page: 187 / 884

1.6.1.5 Erase all flash contents
In addition to software, the entire flash memory may be erased external to the flash
memory via the SW-DP debug port by setting MDM-AP CONTROL[0]. MDM-AP
STATUS[0] is set to indicate the mass erase command has been accepted. MDM-AP
STATUS[0] is cleared when the mass erase completes.
1.6.1.6 FTFA_FOPT register
The flash memory's FTFA_FOPT register allows the user to customize the operation of
the MCU at boot time. See
FOPT boot options for details of its definition.
1.6.2 Flash memory controller configuration
This section summarizes how the module has been configured in the chip. For a
comprehensive description of the module itself, see the module’s dedicated chapter.
See MCM_PLACR register description for details on the reset configuration of the FMC.
Flash memory
controller
Transfers Transfers
Flash memor
y
Cr
ossbar s
witch
MCM
Figure 1-18. Flash memory controller configuration
Table 1-28. Reference links to related information
Topic Related module Reference
Full description Flash memory
controller
Flash memory controller
System memory map — System memory map
Clocking — Clock distribution
Transfers Flash memory Flash memory
Transfers Crossbar switch Crossbar switch
Register access MCM MCM
Memories and memory interfaces
MKW01Z128 MCU Reference Manual, Rev. 3, 04/2016
56 Freescale Semiconductor, Inc.