NXP Semiconductors MKW01Z128, Reference Manual, Page: 821 / 884

NOTE
When TSI is working, the configuration bits (GENCS[TSIEN],
GENCS[TSIIEN], and GENCS[STM]) must not be changed.
The EOSF flag is kept until the software acknowledge it.
Address: 4004_5000h base + 0h offset = 4004_5000h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
OUTRGF
0
ESO
R
MODE REFCHRG DVOLT EXTCHRG
W
w1c
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
PS NSCN
TSIEN
TSIIEN
STPE STM
SCNIP
EOSF
CURSW
0
W
w1c
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
TSIx_GENCS field descriptions
Field Description
31
OUTRGF
Out of Range Flag.
This flag is set if the result register of the enabled electrode is out of the range defined by the
TSI_THRESHOLD register. This flag is set only when TSI is configured in non-noise detection mode. It
can be read once the CPU wakes. Write "1" , when this flag is set, to clear it.
30–29
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
28
ESOR
End-of-scan or Out-of-Range Interrupt Selection
This bit is used to select out-of-range or end-of-scan event to generate an interrupt.
0 Out-of-range interrupt is allowed.
1 End-of-scan interrupt is allowed.
Table continues on the next page...
Register definition
MKW01Z128 MCU Reference Manual, Rev. 3, 04/2016
690 Freescale Semiconductor, Inc.