Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 92 / 564

STEERING AND FRONT SUSPENSION Steering Column
Page 7-2 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
7
Steering Wheel Removal, Continued:
STEERING WHEEL INSTALLATION
1. Install the steering wheel on the hex portion of the steering shaft. Align the hex fitting of the wheel with
the steering column shaft (Figure 7-1, Page 7-2) .
2. Install the steering wheel retaining bolt, and tighten the bolt to 13 ft-lb (17.6 N·m).
3. Install the steering wheel center cap by aligning the two pins on the cap with the two holes in the wheel.
4. Gasoline vehicles: Connect the spark plug wire.
5. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
STEERING COLUMN
See General Warning, Section 1, Page 1-1.
STEERING COLUMN REMOVAL
1. Turn the key switch OFF, and place the Forward/Reverse handle in the NEUTRAL position. Chock the
wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Remove the steering wheel. See Steering Wheel Removal on page 7-1.
4. Remove the instrument panel. See Instrument Panel Removal, Section 4, Page 4-3.
5. Raise the hood. See Front Fascia Removal, Section 4, Page 4-4.
6. Loosen the top bolt from the steering column shaft at the universal joint (Figure 7-4, Page 7-3) .
7. Remove the bottom bolt from the rack and pinion shaft at the universal joint.
8. Remove the three nuts from the steering column mount bolts.
NOTE: Bolts are pressed into the steering column mount bracket.
9. Remove the steering column, and pull the shaft up through the hole in the splash guard.
Figure 7-1 Steering Wheel Puller Figure 7-2 Steering Wheel Puller
2
5
4
1
18
6
B 5
2
6