Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 302 / 564

ELECTRICAL COMPONENTS: KAWASAKI POWERED GASOLINE VEHICLESReverse Warning Buzzer Limit Switch (If Equipped)
Page 12a-12 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
12A
REVERSE WARNING BUZZER LIMIT SWITCH (IF EQUIPPED)
See General Warning, Section 1, Page 1-1.
Testing the Reverse Warning Buzzer Limit Switch
See Test Procedure 19, Section 11a, Page 11a-29.
Reverse Warning Buzzer Limit Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Disconnect the wires from the reverse warning buzzer limit switch (Figure 12a-7, Page 12a-11) .
5. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
6. Remove the limit switch.
Reverse Warning Buzzer Limit Switch Installation
1. Install the reverse warning buzzer limit switch in the reverse order of removal.
2. Place the Forward/Reverse handle in the REVERSE position.
3. Tighten the limit switch mounting screws so that they are snug, but the limit switch can still be rotated in
the adjustment slot (Figure 12a-8, Page 12a-12) .
4. Rotate the limit switch so that the lobe on the Forward/Reverse handle activates the limit switch as shown
(Figure 12a-9, Page 12a-12) .
5. Hold the limit switch in position and tighten the mounting screws and nuts to 4 in-lb (0.5 N·m). See fol-
lowing CAUTION.
Figure 12a-8 Reverse Warning Buzzer Limit Switch
Adjustment Slot
Figure 12a-9 Reverse Warning Buzzer Limit Switch
(Properly Adjusted)