Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 500 / 564

HYDRAULIC ATTACHMENT SYSTEM Attachment Interface
Page 16-2 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
16
4. Relieve pressure in the desired circuit:
4.1. For the tilt circuit, slightly retract the tilt cylinder to relieve most of the built up pressure.
4.2. For the lift circuit, activate the float feature to relieve pressure.
4.3. For the auxiliary circuit, if equipped, turn the key switch to the OFF position and press the auxiliary
hydraulic switch to the right and then to left several times to relieve pressure.
5. Once pressure is relieved from the circuit(s) to be serviced, make sure the key switch is in the OFF posi-
tion and set the joystick ON/OFF switch to OFF.
ATTACHMENT INTERFACE
INSPECTION
Hand Lever
ý
WARNING
• The pins must extend through the holes in attachment. Lever must be fully engaged in the
locked position. Failure to secure pins can allow attachment to come off and cause injury or
death.
1. Move the locking hand lever (1) to engage and disengage the pins (2) (Figure 16-1, Page 16-2) . The
lever and pins must move freely.
2. The pins (2) must extend through the holes in the attachment mounting frame (Figure 16-2, Page 16-2) .
If the pin does not extend through the hole, the attachment will be loose and can come off the attachment
interface.
3. Inspect the linkages and pins for excessive wear or damage (Figure 16-3, Page 16-3) . Replace any
parts that are damaged, bent or missing. Keep all fasteners tight.
Figure 16-1 Hand Lever Figure 16-2 Attachment Pins
1
2
2