Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 373 / 564

KAWASAKI GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Engine Control Linkages
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13a-21
13A
NOTE: Tie a heavy nylon cord to the cable end before removing the cable. Allow the cord to travel from the
engine compartment up through the instrument panel hole. Use the cord to route the cable during
installation.
Choke Cable Installation
1. Secure a new choke cable to the nylon cord outside of the instrument panel. At the engine compartment,
pull the nylon cord until the choke cable reaches the engine.
2. Push the choke cable ferrule into the instrument panel hole so the tines engage behind the panel.
3. Secure the choke cable to the frame with the plastic retention clips.
4. Install the engine front cover (4) and secure with pan-head screws tightened to 54 in-lb (6 N·m)
(Figure 13a-19, Page 13a-21) .
5. Feed the Z-shaped cable end (2) of the choke cable through the engine front cover (Figure 13a-19,
Page 13a-21) .
6. Push the cable sheath strain relief (3) into the engine front cover (4) until it snaps into place.
7. Insert and secure the Z-shaped end of the choke cable (2) to the choke lever on the side of the carbu-
retor.
8. Secure the choke cable return spring (1) to the hook on the choke lever (Figure 13a-18, Page 13a-21) .
9. Install the engine top cover and tighten the four bolts to 35 in-lb (4 N·m).
10. Install the center seat plate.
11. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
12. Install the center seat plate (bucket seat vehicles only).
13. Install seat(s).
14. Lower and secure the hood.
ENGINE GOVERNOR ARM
See General Warning, Section 1, Page 1-1.
Figure 13a-18 Choke Cable on Engine Figure 13a-19 Choke Cable Through Front Cover
1
3
2
FRONT
OF VEHICLE
4
3